Infintie/OKHobby ESCs and motors.

[BrianG]

Originally Posted by simplechamp

...You can see they are much longer than Neu leads, so I will probably shorten them....

Be careful doing that. If they truly are extensions of the coil wires, they will have an insulating varnish coating that will be almost impossible to solder. You will need to clean each strand and/or use some type of solvent to remove the varnish.

[simplechamp]

Originally Posted by BrianG

Be careful doing that. If they truly are extensions of the coil wires, they will have an insulating varnish coating that will be almost impossible to solder. You will need to clean each strand and/or use some type of solvent to remove the varnish.

Right, that's why I was requesting some help or more info on how to do so:

Originally Posted by simplechamp

Shortening the leads might be a chore, if you know a good way to remove the enamel coating from the winding leads post here or send me a PM.

[sikeston34m]

Originally Posted by simplechamp

Right, that's why I was requesting some help or more info on how to do so:

Why not run it like it is? Just secure the wires well with ties to minimize vibration. They should last a long time that way.

Then if there's trouble, (breakage) perfect your wire shortening skills.

Those pictures don't look like the advertised pictures. hmmm..........looks good though.

How much was shipping on that bad boy?