1/6th Scale Savage Conversion

[Finnster]

Made a rough tracing of the XL tvps w/ the screw holes I need to keep on a couple peices of paper. I'm then going to separate the pages, line them up, then fill in the middle section later.

I'll take that template and tack it to some thin pressboard so I can cut a couple sample tvps to work on the fitting and placements. Eventually I'll trace those back on paper and use that paper template on the alu tvps I'll cut. Only crappy part is my scanner only does max 14" width, so I have to make overlapping scans.

I traced a few of the interior cutouts, but they are just in pencil on the paper. I won't keep them, but just for ref at this point.