ALZA racing Flux Baja 5b

[Knez]

Small update... I cutted middle "support tower" of the HPI baja roll cage, wich i will not be using and made body mounts. Drilled m3 hole to m4 so i use m4 screw...







I didnt have a lot of black colour left so i finished with white..

[Knez]

Frond body post i made also from support tower form hpi roll cage and i drilled M3 hole in to the traxxar receiver box mounted small part on it, made another hole for body post... this menas my body is secured with 3 body posts.

Well for front part didnt came out as i wanted so i will be putting back front bumper... just sits to low like this as body is a bit higher do to the jubo servos wich dont alowe body to sit lower.

Front part was serured with those 2 lights...srewd 2 screws in and cutted them that screwd the "lights" on.
AS u can see on th last picture, it dosent look good! I just cutted to much and sits to low at the front...







Knez