Just out of curiosity, have you tried? I was planning on adding a bec and extra cap , just to see what kind of difference it makes with it's capabilities. But was thinking when I did, I would try 4s, just to see. Honestly my end plan is a different esc, though.
Just out of curiosity, have you tried? I was planning on adding a bec and extra cap , just to see what kind of difference it makes with it's capabilities. But was thinking when I did, I would try 4s, just to see. Honestly my end plan is a different esc, though.
I have a feeling that the castle firmware will not allow the increased voltage. Read thru the release notes for the MM updates and you will see that after v1.28 they incorporated overvoltage protection. I have a thread about it. I have a feeling they have done this across the board.
Did a run today with 10/54 gearing, ran around 49mph
Amps dropped to 106. Temps were 145 esc, 125 motor
Really make me wonder about the earlier amp readings with the higher gearings. To only see a 1 amp difference between 11 and 13, then lose 10 by dropping to a 10.
Also did a 2s run, it was kinda slow at 33mph, and I could constantly hold wot. But amps went back up to 112