E-lst 2 project xo-1 1717 mm2 6s

[brushless losi]

Getting it together but need ideas for pinion size not for high speeds or crazy torque lookin for cool temps and good runtimes help me out been reading a lot but forgot because everyone has a different setup

[ruudxd]

Most people use a 25 tooth pinion and a 63T spur if I am correct.

[brushless losi]

Got a faulty 1717 had a rattling noise for a new product and now im thinking tekin 1700kv or 1400 kv

[Big House]

I have a custom set-up where I am running a 26/51 combo...fast as stink and torque happy. Running a Big Block Mamba from a XO-1. Check out the following thread.

http://www.rc-monster.com/forum/showthread.php?t=32095

[brushless losi]

How did u lower ur stance and have u fixed ur lst2 from the crash if so how fastate

[brushless losi]

Does ne1 know how to mount the 2 gear pinion clutch bell to a brushless motor becuz I have seen sum people with it on a brushless just need a link or something

[RC-Monster Mike]

http://www.rc-monster.com/proddetail...apter+5mm+bore

[brushless losi]

Thanks out of stock but found it on ebay

[Big House]

Brushless Losi,

Yeah, I got my Losi back on the road. Hitting a tree and plastic does not mix. I reassembled the rear end and all was well. I dropped the stance using some leftover carbon plate glued together. Here is the thread that had the drop blocks in it.

http://www.rc-monster.com/forum/showthread.php?t=32095

[brushless losi]

Should I mount the rx next to esc or servos which causes interferance I have the rx8 t8 and mm2 and 1515 what are the rules for mounting a 2.4 tx

[Big House]

In one of my models, I never had an issue mounting the reciever atop the servo.

[brushless losi]

Just got the tekin becuz I got another effect xo-1 1717 it would prolly work but was used and I paid a high price but was wondering if tekins are easier to turn the motor by hand than castles becuz it seems like it is like butter compared to a 1515 2200kv which is kind of hard is ur xo-1 motor hard to turn by hand