|
03.02.2007, 11:48 AM
Another question, my soldering skills are poor, how good does the soldering have to be on the ubec and motors etc? I don't wanna screw something else up because I made a subpar solder joint that somehow fries something. Really all the soldering I've ever done was directly soldering a 12 volt fan to my hv-maxx esc, and repairing a few broken wires.
Also, an 8xl on 14 cells with mamba max esc and ubec will be a good setup on about a ten lb erevo, right? And run reliably. I'm open to suggestions on other setups, but that seems like a good one to me from my research, and fairly cheap as far as sensorless goes.
Brushless-taking back rc!
E-revo is DONE!
Last edited by mwe-maxxowner; 03.02.2007 at 12:43 PM.
|
Threaded Mode
