baja 5b bl

[Serum]

it's not said that it's more efficient bp.

The 3060/3080 motors of lehner have got 3 wires going to the speedo. but all the other wires/plugs that sit on the rear are for the Wye and Delta configuration.

LOL believe me i read ur thread bout all this lol

and i didnt know that tho, do u use all 6, or just 3?

[Serum]

Three, read my earlier post.

ooops, sorry didnt see that lol

how do u know what goes where to set it up right?

[Serum]

By looking here;

http://lehner-motoren.com/ms30.php?la=en

ohhh, ok thats cool... looks like a pita tho... lol to me ne ways

[steveo]

i think finedesighnrc.com is going to beat you to the punch, they just built a duratrax 1/5 bl truck 22 series lehner and 10s lipo and soon after same setup in 5b buggy check it out

[steveo]

no i'm sorry a 3040 series lehner motor

[jnev]

I actually posted a link to it on the page before, lol.

Originally Posted by ***RC***

I don't kno if you guys have seen this, but sicne this topic was originally fort he baja 5b... here is a new brushless one from Fine Design:

http://www.finedesignrc.com/ct-hpi-hotbodies.asp

FD was at the WRAM show, and I saw the DTX E-firehammer run with a 3080 motor (yes a 3080!). Chris ran it about 5 times total and it practically broke every time! You heard gears stripping everywhere! He told me that they only ran it at about 3hp and that the production models will have 3040's, not 3080's. From talking to him in person a couple times, I really think I saw dollar signs in his eyes!:005: He is nice, but I would rather deal with RC-M mike!

Bye:018:

[Re~Mix]

I think if done right, each could work. However, the cheap resources that finedesign uses will never due such a conversion justice. A big motor like that deserves more than clamps as motor mounts.

[MetalMan]

I hope Chris will be at the RCX show. Then I can give him a piece of my mind! And if I see his (IMO) crappy conversions, I will point out the "crapiness" of them to passers-by.

[glassdoctor]

Ha ha... I can see it now... a spontaneous pick line forms in front of the FD booth... :D

[BrianG]

lol. Just bring a couple of your conversions to show people that there are better designs. :)

[MetalMan]

That would be nice. Mike needs to set up a booth at RCX! I could help him work it :). Hobby People is a major supporter of RCX, and is the hobby store chain that I work for. My boss (the manager) will be hosting the "Try Me" track, so myself and the other employees are going to be bugging him. It should be fun.