RC-Monster Forums  

Go Back   RC-Monster Forums > Support Forums > Brushless

 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old
  (#20)
MetalMan
RC-Monster Mod
 
MetalMan's Avatar
 
Offline
Posts: 5,297
Join Date: Mar 2005
Location: SoCal
04.05.2007, 10:27 PM

Quote:
Originally Posted by AAngel
MM, I have to comment again, that the vid was nice. Your truck seems to run very smoothly without any hiccups. That compro looks like it's doing its job, which is a relief to me, since I just ordered one instead of the Quark.
I would say it runs pretty well. Even though it's the version without heastinks (it's wrapped in heatshrink with only heat spreaders), it runs at a pretty good temperature. In the same truck the MM needed a fan to keep it from thermalling. One problem with this ESC is that the BEC chip burnt out, and so now it sends the main battery's voltage to the receiver. When that happened, it smoked the receiver and servo... But with a RX pack it runs just fine. I might take the shrinkwrap off and add heatsinks to it to make it run even cooler.


SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz
   
Reply With Quote
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump







Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
vBulletin Skin developed by: vBStyles.com